Lighting
Remove and install a new item
← Back to Dashboard
DMC:
S1000DLIGHTING-AAA-D00-0-0-00-00-AA-921-A-A
From location, remove the glass.
Remove the used front yellow bulb.
Discard the used bulb.
Remove the new white bulbfrom the kit.
Install the new white bulb.
Install the glasson the light.
Attach the light fitting on the handlebar.
Apply the protective strip around the handlebar.
Install the washer on the screw.
Use the special screwdriverfrom the toolsetand tighten the screw into the hole at the bottom of the clamp. This safeties the clamp to the handlebar.
From locationRemove the glass.
Remove the used yellow rear bulb.
Discard the used bulb.
Remove the new white bulbfrom the kit.
Install the new white.
Drill a 4mm hole in the middle of the glassin order to allow venting and heat evacuation when the light is switched on.
The glass with the hole may be ordered independently with the reference.
Install the glass with the holeon the light.
Spare Parts (S2000M)
Loading…
No illustration
⚠️ Report Issue
📦 Show Parts
Spare Parts (S2000M)
×
Loading…
Describe the issue...
Thank you! Engineering notified.
Cancel
Send Report